Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

2-2 Fabric OS Message Reference
Publication Number: 53-1000242-01
AUTH-1004
2
Probable
Cause
Indicates an authentication configuration value was set to the specified value. The data type is either
"authentication type" or "DH group type".
Recommended
Action
No action is required.
Severity INFO
AUTH-1004
Message
Probable
Cause
Indicates that the authUtil command has failed to set the authentication configuration value. The data
type is either "authentication type" or "DH group type".
Recommended
Action
Retry the authUtil command.
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
and contact your switch service provider.
Severity ERROR
AUTH-1005
Message
Probable
Cause
Indicates an authentication file corruption.
Recommended
Action
Run the firmwareDownload command to reinstall the firmware.
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
and contact your switch service provider.
Severity ERROR
AUTH-1006
Message
<timestamp>, [AUTH-1004], <sequence-number>,, ERROR, <system-name>,
Failed to set <data type> type to <setting value>.
<timestamp>, [AUTH-1005], <sequence-number>,, ERROR, <system-name>,
Authentication file does not exist: <error code>.
<timestamp>, [AUTH-1006], <sequence-number>,, WARNING, <system-
name>, Failed to open authentication configuration file.