Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 58-57
Publication Number: 53-1000242-01
SEC-1311
58
SEC-1311
Message
Probable
Cause
Indicates that the security enable failed on the fabric because one or more switches in the fabric have
password policies that are not set to the default value.
Recommended
Action
Verify that the security event was planned.
If the security event was planned, run the passwdCfg --setDefault command on each switch in the
fabric to set the password policies to the default value. Then verify with passwdCfg --show that passwd
policies are set to the defaults on all switches and retry the secModeEnable command.
Severity ERROR
SEC-1312
Message
Probable
Cause
Indicates that the passwdCfg parameters changed.
Recommended
Action
Verify that the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security policy.
Severity INFO
SEC-1313
Message
Probable
Cause
Indicates that the passwdCfg parameters were set to default values.
Recommended
Action
Verify that the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security policy.
Severity INFO
<timestamp>, [SEC-1311], <sequence-number>,, ERROR, <system-name>,
Security mode cannot be enabled because one or more of the password
policies is not set to default value.
<timestamp>, [SEC-1312], <sequence-number>,, INFO, <system-name>,
<MESG Message>.
<timestamp>, [SEC-1313], <sequence-number>,, INFO, <system-name>,
The passwdcfg parameters were set to default values.