Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

12-2 Fabric OS Message Reference
Publication Number: 53-1000242-01
FABS-1005
12
Probable
Cause
Indicates that an operation has been interrupted by a signal. This is usually an internal Fabric OS
problem or file corruption.
Recommended
Action
Reboot or power cycle the switch.
Severity WAR NIN G
FABS-1005
Message
Probable
Cause
Indicates that an unsupported operation has been requested. This is usually an internal Fabric OS
problem or file corruption. The possible values for function name and description of problem are:
fabsys_write: Unsupported write operation: process xxx
where "xxx" is the process ID (PID), which could be any whole number.
Recommended
Action
Reboot or power cycle the active CP (for modular systems) or the switch (for single-board systems).
If the message persists, run the firmwareDownload command to update the firmware.
Severity WAR NIN G
FABS-1006
Message
Probable
Cause
Indicates that there is no device in the slot with the specified object type ID in the system module
record. This could indicate that a serious Fabric OS data problem on the switch. The possible values for
function name and description of problem are:
• setSoftState: bad object
• setSoftState: invalid type or unit
• media_sync: Media oid mapping failed
• fabsys_media_i2c_op: Media oid mapping failed
• fabsys_media_i2c_op: obj is not media type
• media_class_hndlr: failed sending media state to blade driver
Recommended
Action
If the message is isolated, monitor the error messages on the switch. If the error is repetitive or if the
fabric failed, fail over or reboot the switch.
<timestamp>, [FABS-1005], <sequence-number>,, WARNING, <system-
name>, <Function name and description of problem> (<ID type>= <ID
number>)
<timestamp>, [FABS-1006], <sequence-number>,, WARNING, <system-
name>, <Function name and description of problem>: object <object
type id> unit <slot>