Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

238 Fabric OS Command Reference
53-1000599-02
fwPortDetailShow
2
fwPortDetailShow
Displays the port information for specified user ports.
Synopsis fwportdetailshow [--p portNumber] | [--s portState]
Description Use this command to print the overall status of a specified port. The output of this command is
different for IPv4 and IPv6 addresses. The overall status is calculated based on the following
contributors:
Port Errors:
LFA Number of link loss occurrences exceeded limit for time period
LSY Number of sync loss occurrences exceeded limit for time period
LSI Number of signal loss occurrences exceeded limit for time period
PER Number of protocol errors exceeded limit for time period
INW Number of invalid words exceeded limit for time period
CRC Number of invalid CRC errors exceeded limit for time period
PSC Port hardware state changed too often
BLP Buffer limited port
SFP Errors:
STM SFP temperature is out of specification
SRX SFP receive power is out of specification
STX SFP transmit power is out of specification
SCU SFP current is out of specification
SVO SFP voltage is out of specification
The overall status may be in one of the following:
Healthy Every contributor is healthy
Marginal One or more contributors are in this status
Faulty Faulty hardware
Offline Port has no connectivity or is disabled
If the overall status is not healthy, the contributing factors also are listed.
Notes This command requires a Fabric Watch license.
Port errors are not supported for virtual ports and SFP errors are not applicable for virtual ports.
The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands This command has the following operands:
--p portNumber Yields a port detail report for a specific user port.