Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

Fabric OS Command Reference 171
53-1000599-02
fcrLsanMatrix
2
• In a dual backbone configuration, execute fcrlsanmatrix --fabricview on the FCR switches to
confirm that the shared edge fabric FIDs have the same access in both backbones.
• Execute fcrlsanmatrix --display -lsan | -fcr and fcrproxydevshow -a Check that the LSAN
binding matrix in the cache is not in conflict with the existing import/export devices that are
displayed on the FCR switch. If there is a conflict, do one of the following:
- Update the LSAN/FCR binding matrix in the cache to allow access for the FIDs that have
imported devices.
- Remove the conflicting import/export devices by updating the LSAN zone in the edge
fabrics.
- Disable the conflicting devices.
Error message (2):
"There may be other FCR switches in the backbone that do not support the LSAN Binding feature or
do not have the same fcrlsanmatrix settings."
"Please refer to the man page for the corrective action."
Corrective actions:
• Check that all FCR switches in the backbone support the LSAN Binding feature, otherwise the
feature is not supported.
• Execute fcrlsanmatrix --fabricview to confirm that all the switches in the backbone have the
same LSAN binding matrix. If not, clear the LSAN binding feature on all the switches and
re-apply the same LSAN binding matrix on all the FCR switches in the backbone.
• In a dual backbone configuration, use fcrlsanmatrix --fabricview on the FCR switches to
confirm that the shared edge fabric FIDs have the same access in both backbones.
Refer to the Fabric OS Message Reference manual for further diagnostic information.
See Also fcrFabricShow, lsanZoneShow, fcrPhyDevShow, fcrProxyDevShow,
fcrRouteShow, switchShow