Manualshelf

Cisco MDS 9200 Series Hardware Installation Guide (OL-16188-01, April 2008)

ManualsBrandsHP ManualsStorageHP SN8000C 13-Slot Supervisor 2A Fabric 3 Director Switch
41424344454647484950
1-28
Cisco MDS 9200 Series Hardware Installation Guide
OL-16188-01
Chapter 1 Product Overview
Services Modules
LEDs on the Storage Services Module
Table 1-9 describes the LEDs for the Cisco MDS 9000 Family Storage Services Module.
32-Port Fibre Channel Advanced Services Module
The Cisco MDS 9000 Family 32-port Fibre Channel Advanced Services Module (ASM) enables pooling
of heterogeneous storage for increased storage utilization, simplified storage management, and reduced
total cost of storage ownership. The ASM incorporates all the capabilities of the Cisco MDS 9000
DS-X9032 Fibre Channel switching module and also provides scalable, in-band storage virtualization
services. The ASM module makes it possible to allocate bandwidth optimally.
Table 1-9 LEDs for the Cisco MDS 9000 Family Storage Services Module
LED Status Description
Status Green All diagnostics pass. The module is operational (normal
initialization sequence).
Orange One of the following occurs or occurred:
• The module is booting or running diagnostics (normal
initialization sequence).
• The inlet air temperature of the system exceeded the
maximum system operating temperature limit (a minor
environmental warning). To assure maximum product life,
you should immediately correct the environmental
temperature and restore the system to normal operation.
Red One of the following occurs or occurred:
• The diagnostic test failed. The module is not operational
because a fault occurred during the initialization sequence.
• The inlet air temperature of the system exceeded the safe
operating temperature limits of the card (a major
environmental warning). The card shut down to prevent
permanent damage.
Speed On 2-Gbps mode.
Off 1-Gbps mode.
Link Solid green Link is healthy.
Steady flashing
green
Link is healthy and beacon is enabled.
Intermittent
flashing green
Link is up and traffic is flowing through port.
Solid yellow Link is disabled by software.
Flashing yellow A fault condition exists.
Off No link.