Brocade Fabric OS v7.0.2e Release Notes v1.0

Fabric OS v7.0.2e Release Notes v1.0 Page 18 of 53
6
If operating with
FOS v6.2.2e or earlier
, Adaptive Networking QoS must be disabled when connecting to 16G FC
platform. Otherwise, ISL will segment.
7
Connectivity to FC SAN is established via VDX6730 connected to FCR running FOS v7.0.1 or later. FCR platforms
supported include 5100, VA-40FC, 5300, 7800, DCX, DCX-4S, DCX 8510-8, DCX 8510-4, 6510. For higher FCR
backbone scalability (refer to separate “Brocade SAN Scalability Guidelines” documentation for details), please use
5300, DCX, DCX-4S, DCX 8510-8, DCX 8510-4.
Zoning Compatibility Note
:
Users are recommended to upgrade to the following versions of firmware when interoperating with a switch
running FOS v7.0 or later in the same layer 2 fabric to overcome some of the zoning operations restrictions
that otherwise exist:
Main code level
Patch code levels with full zoning
compatibility
FOS v6.2
FOS v6.2.2d or later
FOS v6.3
FOS v6.3.2a or later
FOS v6.4
FOS v6.4.1 or later
If there are switches running FOS versions lower than the above listed patch levels in the same fabric as a
switch with FOS v7.0 or later, then cfgsave and cfgenable operations
initiated
from these switches will fail if
the zoning database is greater than 128KB. In such scenarios zoning operations such as cfgsave/cfgenable
can still be performed successfully if initiated from a switch running FOS v7.0 or later.
Blade Support
Fabric OS v7.0.2 software is fully qualified and supports the blades for the DCX/DCX-4S noted in the following
table
:
DCX/DCX-4S Blade Support Matrix
16-, 32-, 48- and 64-port 8Gbit port blades (FC8-16,
FC8-32, FC8-48, FC8-64) and the 6-port 10G FC blade
(FC10-6)
Supported with FOS v6.0 and above (FC8-64 requires
FOS v6.4) with any mix and up to 8/4 of each. No
restrictions around intermix.
Intelligent blade Up to a total of 8/4 intelligent blades. See below for
maximum supported limits of each blade.
FCIP/FC Router blade (FR4-18i) Up to a maximum of 4 blades of this type. This can be
extended under special circumstances, but must be
approved by Brocade’s Product Team. Up to 8 FR4-18i
blades can be installed in a DCX if they are used only
for FCIP without routing.
Note
: FR4-18i cannot coexist with FX8-24 in FOS v7.0
or later
FR4-18i does not support EX-ports, FC FastWrite and
WAN optimization features in FOS v7.0 or later
FR4-18i supports VEX ports on FOS v7.0 or later
Virtualization/Application Blade (FA4-18)
Not supported on FOS v7.0 or later
Encryption Blade (FS8-18)
Up to a maximum of 4 blades of this type.