Brocade Fabric OS v7.0.2e Release Notes v1.0

Fabric OS v7.0.2e Release Notes v1.0 Page 33 of 53
• HA failover on DCX/DCX-4S/DCX 8510 platforms while running FOS v7.0 or later firmware
• Firmware upgrade from v7.0 to a later release on Brocade 300, 5100, VA-40FC, 5300,
6510
• Firmware upgrade from v7.0.1 to a later release on Brocade 6505
• The QSFP information in the sfpshow output will indicate the ID field as all zeros. This is as
designed.
ras080:FID128:root> sfpshow 5/32
QSFP No: 8 Channel No:0
Identifier: 13 QSFP+
Connector: 12 MPO Parallel Optic
Transceiver: 0000000000000000 16_Gbps id
• It is recommended that for directors with more than 300 E_Ports, the switch be disabled prior
to executing the “switchCfgTrunk” command (used to disable or enable trunking on the
switch).
• During non-disruptive firmware upgrades, E_Ports in R-RDY mode may cause some frame
drops on the E-port links.
• For the configure command, in FOS v6.4, or later the default value that displays for Maximum Logins
per switch is different than the value that displays in FOS v6.3.x. The default value has not changed; it
was displayed incorrectly in FOS v6.3.x, and is now corrected.
• The Brocade Network Advisor seed switch should always have the highest FOS version used in the
fabric.
• For login authentication through RADIUS, Brocade switch should be able to reach RADIUS servers
through TCP authentication port (default 1812) and accounting port (default 1813). Both of these
ports must be kept open in any firewall settings.