HP StorageWorks 2300 Modular Smart Array CLI reference guide (500912-001, January 2009)

HP StorageWorks 2300 Modular Smart Array CLI reference guide 85

set debug-log-parameters

Description This command is for use by or with direction from a service technician.

Sets the types of debug messages to include in the Storage Controller debug log. If multiple types

are specified, use spaces to separate them and enclose the list in double quotes.

Syntax

set debug-log-parameters message-type+|- [...]

Parameters message-type+|-

One of the following message types, followed by a plus (+) to enable or a minus (-) to disable

inclusion in the log:

• awt: Auto-write-through feature debug messages

• bkcfg: Internal configuration debug messages

• cache: Cache debug messages

• capi: Internal Configuration API debug messages

• capi2: Internal Configuration API tracing debug messages

• disk: Disk interface debug messages

• dms: Snapshot feature debug messages

• emp: Enclosure Management Processor debug messages

• fo: Failover/recovery debug messages

• fruid: FRU ID debug messages

• host: Host interface debug messages

• ioa: I/O interface driver debug messages (standard)

• iob: I/O interface driver debug messages (resource counts)

• ioc: I/O interface driver debug messages (upper layer, verbose)

• iod: I/O interface driver debug messages (lower layer, verbose)

• mem: Internal memory debug messages

• misc: Internal debug messages

• msg: Inter-controller message debug messages

• mui: Internal service interface debug messages

• raid: RAID debug messages

• rcm: Removable-component manager debug messages

• res2s: Internal debug messages

Example Include RAID and cache messages, exclude EMP messages, and leave other message types

unchanged:

# set debug-log-parameters "raid+ cache+ emp-"

Success: Command completed successfully. - Debug-log parameters were changed.