HP ProLiant Support Pack 9.10 User Guide

To support many HP value-add software deliverables included in the Linux PSP, you must install
the following platform-specific compatibility libraries:
• For Red Hat Enterprise Linux 5 x86 servers:
compat-libstdc++-296-2.96-132.7.2.i386 or later◦
◦ lm_sensors-2.8.7-2.i386 or later
◦ net-snmp-5.3.1-14.el5.i386 or later
◦ perl (required to provide the libperl.so)
◦ libnl (required for QLogic and Emulex drivers)
• For Red Hat Enterprise Linux 5 AMD64/EM64T servers:
compat-libstdc++-296-2.96-132.7.2.i386 or later◦
◦ lm_sensors-2.8.7-2.i386 or later
◦ net-snmp-5.3.1-14.el5.i386 or later
◦ perl (required to provide the libperl.so)
◦ libnl (required for QLogic and Emulex drivers)
• For Red Hat Enterprise Linux 5 AMD64/EM64T servers:
compat-libstdc++-296-2.96-132.7.2.i386 or later◦
◦ lm_sensors-2.8.7-2.x86_64 or later
◦ net-snmp-5.3.1-14.el5.x86_64 or later
◦ perl (required to provide the libperl.so)
◦ libnl (required for QLogic and Emulex drivers)
Minimum requirements for Red Hat Enterprise Linux 6 servers
NOTE: The following versions listed are needed as a minimum. Later versions of these might be
used as well.
Ensure that each NIC has an IP address assigned. To get the IP address assigned to a NIC, enter
the dhclient command in the console, which enables the NIC interfaces and retrieves an IP
address. If a NIC does not have an IP address, HP SUM appears to hang on start up.
• Red Hat Enterprise Linux console mode
No X console in either x86 or x86_64 servers. To run HP SUM in silent mode, you must install
the base server with defaults and the following RPMs:
◦ lm_sensors-libs-3.1.1-10.el6.<arch>.rpm
◦ net-snmp-libs-5.5-27.el6.<arch>.rpm
◦ net-snmp-5.5.27.el6.<arch>.rpm
◦ kernel-headers-2.6.32-71.el6.<arch>.rpm
◦ redhat-rpm-config-9.0.3-25.el6.noarch.rpm
◦ kernel-devel-2.6.32-71.el6.<arch>.rpm
12 Deploying PSPs