HP ProLiant Storage Server User Guide (440584-003, September 2007)

1
2
3
4
5
6
7
Figure 31 DL320s front panel
Ta ble 14 DL320s front panel compon en ts
Item Description
Status
1
UID button/LED
Blue = Identification is activated.
Flashing blue = System is being remotely managed.
Off = Identification is deactivated.
2
Internal health LED
Green = System health is normal.
Amber = System is degraded. To identify the component in a
degraded state, see the system board LEDs.
Red = S yst
em critical. To identify the component in a critical
state, se
esystemboardLEDs.
Off = Syst
em health is normal (when in standby mode).
3
NIC 1 link/activity LED
Green=Networklinkexists.
Flashing green = Network link and activity exist.
Off = No link to network exists.
If power is off, view the LEDs on the RJ-45 connector for status
by referring to the rear panel LEDs.
4
NIC 2 link/activity LED
Green=Networklinkexists.
Flashing green = Network link and activity exist.
Off = No link to network exists.
If power is off, view the LEDs on the RJ-45 connector for status
by referring to the rear panel LEDs.
5
Power On/Standby button and
system power LED
Green = System is on.
Amber = System is shut down, but power is still applied.
Off = Power cord is not attached, power supply failure has
occurred, no power supplies are installed, facility power is not
available, or the DC-to-DC converter is not installed.
6
SAS/SATA Fault/UID LED
(amber/blue)
See
“SAS and SAT A hard drive LED combinations” on page 130.
7
SAS/SATA Online LED (green)
See
“SAS and SAT A hard drive LED combinations” on page 130.
HP ProLiant Storage Server 129