9.5 HP P4000 VSA Installation and Configuration Guide

4. Select the VSA.vmx file and click Open.
5. Edit the VSA settings as required by the VMware console you are using. Select the appropriate
network mode:
• Bridged
• NAT
• Host-only
NOTE: All VSAs on the same platform should use the same networking mode. When running
multiple VSAs on a single host, use NAT or Host-only networking mode, and use DHCP to
assign IP addresses to the VSAs.
6. Power on the VSA.
7. Use the Configuration Interface to set the IP address and host name as described in “Powering
on the VSA and setting IP address and hostname” (page 9).
28 Using the VMware VSA laptop demo