HP Officejet Pro X series - Printbar Install Guide

2
3 4

Insert the printbar lift lock tool into the printbar lock mount,
rotate the tool counter-clockwise.
CAUTION: Do not use excessive force when installing the printbar
lift lock tool. The printbar may not move when the tool is
installed.
NOTE: The printbar lift lock tool may look dierent than what is
shown here.
CAUTION: The printbar lift lock tool must remain in place until
either the printbar is removed, or the service sled assembly is
reinstalled in the product. If the printbar drops to the bottom of
the product, the printbar might be damaged, and likely will need
to be replaced.
Locate the service sled cartridge drive shaft (callout 1).
5 6
Mount the service sled advance tool on the drive shaft.
NOTE: On older products, part of the base material may need
to be removed to mount the service sled advance tool on the
drive shaft.
Turn the tool clockwise to fully advance the service sled forward.