User Guide

Charge and use the battery

WARNING! Charge the battery for 4 hours before using the battery for the first

time. Because the battery is normally warm while it is charging, do not charge it in

a briefcase or other confined space as this might cause the battery to overheat.

NOTE: The AC adapter is normally warm to the touch when plugged into an AC

outlet.

NOTE: Wireless printing uses more battery power than wired printing. For

information on checking the battery charge level, see

Install and use the battery.

To install the battery

NOTE: You can install the battery with the device turned on or off.

1. Slide the battery into the battery slot at an angle, until the contacts on the battery

are flush with the contacts in the battery slot. The battery contact cover slides open.

2. Push the battery into the battery slot until the battery clicks into place.

3. Plug in the AC adapter and turn on the device. Allow the battery to charge for four

hours before using the battery for the first time. Subsequently, the battery charge

light is green when the battery is charging, and turns off when the battery is fully

charged.

4. After the battery is fully charged, you can use the device without connecting to the

AC power supply.

Install and use the battery