HP 1200w NFC/Wireless Mobile Print Accessory - Installation Guide
ZZZKSFRPJR2-B
1
2
NFC/Wireless1200w Mobile Print Accy
Lea esto primero
www.hp.com/support
HP Officejet 100/150 HP LaserJet
Regulatory Model Identication Number
For regulatory identication purposes, this product is assigned
a Regulatory Model Number (RMN). The RMN for your product is
RSVLD-1302. The RMN should not be confused with the market-
ing model number (for example, HP 1200w Mobile Print Acces-
sory) or the HP product number (E5K46A).
Notice for the U.S.A.
This device complies with Part 15 of the Federal Communication
Commission rules. Operation is subject to the following two con-
ditions: 1) this device may not cause harmful interference, and
2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a commercial environment. This
equipment generates, uses and can radiate radio frequency en-
ergy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference, in which case the user will be required to
correct the interference at this own expense. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: The FCC requires the user to be notied that any
changes or modications made to this device that are not
expressly approved by Hewlett-Packard Company may void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received,including interference that may cause undesired operation.
Warning – Exposure to Radio Frequency Radiation Although the
radiated output power of this device isbelow the FCC radio expo-
sure limits, the device should be used in such a manner that the
potential for humancontact with the antennas during normal op-
eration is minimized. To avoid the possibility of exceeding theFCC
radio frequency exposure limits, human proximity to the antenna
should not be less than 20 cm(8 inches) during normal operation.
Notice for Canada
This device complies with the limits for a Class B digital device
and conforms to Industry Canada standard ICES-003. Products
that contain a radio transmitter comply with Industry Canada
standard RSS210 and are labeled with an IC ID.
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
This equipment complies with Canada radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of 20
cm between the radiator and personnel.
Note pour le Canada
Cet appareil numérique de la classeBest conforme à la norme
ICES-003 d’Industry Canada. La radio sans l de ce dispositif
est conforme à la certication RSS 210 d’Industry Canada et est
étiquetée avec un numéro d’approbation IC.
Le fonctionnement est soumis aux deux conditions suivantes :
(1) Cet appareil ne doit pas provoquer d’interférences et (2) doit
accepter toute réception d’interférence, y compris les interférences
susceptibles de générer un fonctionnement indésirable de l’appareil.
Cet équipement respecte les limites d’exposition aux radiof-
réquences canadiennes applicables dans un environnement non
contrôlé. Cet équipement doit être installé et fonctionner à une
distance minimale de 20 cm entre le radiateur et votre corps.
© 2013 Copyright Hewlett-Packard Development Company, L.P.
Reproduction, adaptation or translation without prior written permis-
sion is prohibited, except as allowed under the copyright laws.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in
the ex press warranty statements accompanying such products
and services.
Nothing herein should be construed as constituting an additional
war ranty. HP shall not be liable for technical or editorial errors
or omissions contained herein.
Reproduction, adaptation or translation without prior written permis-
sion is prohibited, except as allowed under the copyright laws.
La reproduction, l'adaptation ou la traduction de ce document sans
l'autorisation écrite préalable de Hewlett-Packard est interdite, sauf
dans des conditions conformes aux lois relatives au copyright.
Les informations contenues dans ce document peuvent être modi-
ées sans préavis.
Les seules garanties pour les produits et servicesHP sont décrites
dans les déclarations de garantie expresse qui accompagnent ces
produits et services. Les informations contenues dans ce document
ne constituent en aucun cas une garantie supplémentaire. HPn'est
pas responsable des erreurs d'ordre technique ou éditorial ou des
omissions contenues dans ce document.
*5851-6060*
*5851-6060*
5HY%
www.hp.com