HP StoreEver Tape Libraries Failover User Guide (5697-3323, June 2014)
Table Of Contents
- HP StoreEver Tape Libraries Failover User Guide
- Contents
- 1 Overview
- 2 Enabling basic path failover
- 3 Installing advanced path failover
- 4 Preparing the switches and hosts for failover
- 5 Configuring failover for the HP StoreEver ESL G3 Tape Libraries
- 6 Configuring failover for HP StoreEver MSL6840 Tape Libraries
- 7 Configuring failover for other HP StoreEver MSL Tape Libraries
- 8 Installing and using Windows advanced path failover drivers
- 9 Installing and using Linux advanced path failover drivers
- 10 Installing and using HP-UX advanced path failover drivers
- 11 Troubleshooting failover operation
- 12 Advanced troubleshooting techniques
- 13 Support and other resources
- A Data Protector device discovery with advanced path failover
- Index
Figure 16 Drivers and device objects
Device manager view
The Windows Device Manager shows the instances of the failover paths which are configured
Figure 18 (page 42).
In the system shown in Figure 17 the library has two tape drives and each tape drive has two
primary ports attached to a different switch. Each drive port presents both tape drive (SSC) and
tape library (SMC) devices. One of the drives will be configured to present the active tape library
device paths and the second drive will be configured to present passive tape library device paths.
All tape drive paths are active.
40 Installing and using Windows advanced path failover drivers