MSL5000 and 6000 Series Tape Libraries User Guide

Operation
86 HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
Figure 47: View SCSI options screen (two-drive model shown)
Table 7 lists and describes the available SCSI Options selections. (See Library
tape drive locations on page 21 for an illustration of the drive numbering scheme.)
Table 7: View SCSI Options
Option Description
Drive 0 Bus ID Lets you set the SCSI addresses of drive 0. The designators
Drive 0 (outer tape drive) through Drive n refer to the first
through nth drives, counting from right to left starting with
the master unit in a scaled Library system. Default is 1.
Drive 1 Bus ID Lets you set the SCSI addresses of drive 1. The designators
Drive 1 (inner tape drive) through Drive n refer to the
second through nth drives, counting from right to left
starting with the master unit in a scaled Library system.
Default is 2.
Drive 2 Bus ID
(four-drive models
only)
Lets you set the SCSI addresses of drive 2. The designators
Drive 2 (lower, outer tape drive) through Drive n refer to
the third through nth drives, counting from right to left
starting with the master unit in a scaled Library system.
Default is 3.
Drive 3 Bus ID
(four-drive models
only)
Lets you set the SCSI addresses of drive 3. The designators
Drive 3 (lower, inner tape drive) through Drive n refer to
the fourth through nth drives, counting from right to left
starting with the master unit in a scaled Library system.
Default is 4.