HP StoreEver MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and Service Guide (AK378-96059, December 2012)

Table 41 Main error codes (continued)
Details and solutionDescriptionError code
magazine and then the lower-left magazine was
replaced with a one-slot mailslot magazine.
with the new mailslot configuration. Note: You
will need to reconfigure your backup software.
• If the issue continues, inspect the magazine
for damage and missing light pipes or
magazine prism pieces (clear plastic pieces
in each slot).
• Retry the backup with a token with space for
more keys.
NOTE: Each token can hold 100 keys. Keys
cannot be overwritten or deleted; only unique
keys will be written to the token.
Key server token backup not successful (not
enough available space on target token)
E1
• Update the library firmware to the current
version.
Unsupported hardware detected. Some hardware
that is connected to the library requires updated
library firmware.
E2
Error during key server token backup; backup
process unsuccessful.
E3
• Retry the backup with a different token.
• If the error occurs again, contact HP customer
support.
Drive firmware does not support encryption.E4
• Ensure that all tape drives that support
encryption (LTO-4 and later generations) are
at the minimum firmware required for the
Encryption Kit:
◦ Ultrium 1760 SCSI: W22W
◦ Ultrium 1760 SAS: U26W
◦ Ultrium 1840 SCSI: B45W
◦ Ultrium 1840 SAS: H44W
• If necessary, update the tape drive firmware
to the current version.
• When encryption is enabled with the
Encryption Kit, ensure that all tape drives in
the logical library support encryption (LTO-4
and later generations). When possible, avoid
including LTO-2 and LTO-3 tape drives in a
logical library when encryption is enabled.
Drive generation does not support encryption.E5
Key Server Token restore process did not
complete, Key Server Token restore failed.
E6
• Retry the operation on the same key server
token.
• Retry the operation on a new key server token.
Incorrect Key Server Toke Type. Token not
supported within this device.
E7
• Verify that the USB device is an HP key server
token from the HP 1/8 G2 & MSL Encryption
Kit.
• Retry the operation on a new key server token.
• The first MSL2024 libraries do not support the
Encryption Kit. Contact your HP service
representative to upgrade your MSL2024
chassis to a newer version.
Encryption Kit not available due to incompatible
library controller.
E8
Drive exceeded temperature specificationF0
• Check ambient temperature to ensure that it
is within operating specifications.
Error codes 177