HP StorageWorks MSL2024 Tape Library firmware release notes Firmware version 4.20 (AK378-96010, August 11, 2008)

6. Press Next until the screen displays the lename of the Autoloader rmware le on the USB drive.
Press Enter to select the rmware le.
7. If the upgrade failed, press Enter to display the error code and message describing the cause of
the failure.
8. When the upgrade is complete, remove the USB ash drive from the USB port.
Determining c
urrent version
To nd the vers
ion of rmware installed on the Library from the RMI, see the Suppor t: Firmware screen.
To nd the version of rmware installed on the Library from the OCP:
1. From the Hom e screen, press Next until the screen d isplays Status/Information.PressEnter to select.
2. Press Next un
til the screen displays Autoloader information.PressEnter to select.
3. Press Next until the screen displays Firmware rev..PressEnter to select.
Supersedes history
IMPORTANT:
When updating to li brary rmware version 2.00 or higher from r m w a r e 1. 70 o r 1. 8 0 w i t h o u t rst
updating to 1.91, you will get an “Invalid Robotic Library rmware” error (83 02). To resolve this issue,
update the library rmware a second time to update the robotics rmware to the proper level.
IMPORTANT:
Several conguration settings are reset to defaults if the Library is upgrading from library rmware
ve rs i o n s 1. 70 o r 1. 8 0 :
M ailslot is set to disabled.
Drive 1 SCSI ID is set to 4.
Drive 2 SCSI ID is set of 5.
Master Drive (Library LUN hosted by) is set to Drive 1.
Drive 1 power is set to on.
Drive 2 power is set to on.
Library Mode is set to Automatic.
Autoload Mode is disabled.
Loop Mode is disabled.
All vers
ions not listed are inactive. Versions m arked manufacturing only are not available for download.
Firmware Version
Released
Status
1. 91
5/31/2006
Active bridge only
3.7 0
2/20/20
08
Active
3.80
6/9/2008 Active manufacturing only
4.20
8/11/2008
Active
Effective date
August 11, 2008
HP StorageWorks MSL2024 Tape Library rmware release notes
5