MSL6480 Getting Started Guide (rev 3) (QU625-96331, April 2014)

2. Slide the inner rails into the middle rails. Slide the module into the rack.
a. Once the module is secure on the rails, remove the protective tape on the front of the
module around the thumbscrews.
b. Depress the release clips on both rails and then slide the module completely into the rack.
If the module does not go fully into the rack the first time, pull the module back out to the
lock position and insert it again.
1
2
3. If you are installing multiple modules, verify that this module has been installed directly above
or below its adjacent module and is contained within the correct 6U volume.
Installing the modules in the rack 21