HP StorageWorks MSL Library Extender user guide (AQ746-96005, September 2009)
Table Of Contents
- HP StorageWorks MSL Library Extender user guide
- Table of Contents
- 1 Features and overview
- 2 Configuring and operating an extended library
- 3 Installing the Library Extender
- Identifying product components
- Downloading product documentation
- Determining the master and lower Library
- Saving the Library configurations
- Upgrading the Library firmware
- Enabling extended mode
- Removing the cartridges from the Libraries
- Powering off the Libraries
- Positioning the Libraries in a rack
- Relocating tape drives
- Removing and replacing drive bay covers
- Removing the USB device and Ethernet cable from the lower Library
- Extending the pull-out tab
- Aligning the Libraries
- Installing the Extender
- Powering on the extended library
- Verifying the installation
- 4 Using diagnostic tools and troubleshooting
- 5 Servicing the Library Extender
- Replacing the Library Extender
- Removing the Library Extender
- Removing a cartridge from the Extender
- Repackaging the Library Extender
- Releasing the magazines manually
- 6 Support and other resources
- A Technical specifications
- B Electrostatic discharge
- C Regulatory compliance notices
- Glossary
- Index
IMPORTANT:
Provides clarifying information or specific instructions.
NOTE:
Provides additional information.
TIP:
Provides helpful hints and shortcuts.
Customer self repair
HP CSR programs allow you to repair your StorageWorks product. If a CSR part needs replacing,
HP ships the part directly to you so that you can install it at your convenience. Some parts do not
qualify for CSR. Your HP-authorized service provider will determine whether a repair can be
accomplished by CSR.
For more information about CSR, contact your local service provider, or see the CSR website:
http://www.hp.com/go/selfrepair
HP StorageWorks MSL Library Extender user guide 69