HP Insight Management 7.3 Support Matrix

Table 62 Requirements and capabilities for HP ProLiant workstation blades
Intelligent
Power
Discovery
3
Data
Center
Power
Control
1,2
Calibrated
Maximum
Power
Power
Metering
Data
Center
Thermal
Mapping
Dynamic
Power
Capping
Power
Regulator
Minimum
system BIOS
version
Minimum
iLO or OA
firmware
version
Server
model
✓✓✓✓✓
4
✓8/5/2008iLO 2
version
ProLiant
xw2x220c
1.60 or
later.
OA version
2.30 or
later.
✓✓✓✓✓
5
✓7/31/2007iLO 2
version
ProLiant
xw460c
1.30 or
later
✓✓✓✓✓✓7/31/2007iLO 2
version
ProLiant
WS460c
G6 1.30 or
later
✓✓✓✓✓✓I31
05/23/2012
iLO 4
version
ProLiant
WS460c
Gen8 1.10 or
later
✓✓✓✓✓✓I31
08/26/2013
iLO 4
version
ProLiant
WS460c
1.30 or
later
Gen8 (with
Intel EP v2
Xeon
processor)
1
Data Center Power Control works only on Primary Addresses of a system and cannot detect a system with a non-primary
address. If a system has IPV4 as a primary address and IPV6 as a non-primary address, Data Center Power Control only
works with the IPV4 address.
2
For VMhost with only an IPV6 address. Data Center Power Control cannot perform a graceful shutdown of guests. It will
only shutdown the hosts.
3
The Intelligent Power discovery feature is not supported when iPDU is configured with iPV6 addresses only
4
This server supports only Power Capping. It does not support Dynamic Power Capping.
5
When you are implementing power capping for HP BladeSystems, HP recommends that you use Enclosure Dynamic
Power Capping set through the Onboard Administrator or Insight Control power management user interface. To use
Enclosure Dynamic Power Capping, you must upgrade your iLO 2 firmware to version 1.70 or later and iLO 3 to version
1.0 or later. HP recommends that you update your system ROM to version 10/1/2008 or later for iLO 2, and May
2010 or later for iLO 3 for G7 servers. For some older BL460c servers, the iLO 2 firmware might not be able to
automatically update the Dynamic Power Capping hardware circuit. In these instances, the Onboard Administrator will
compensate for the absence of the internal hardware circuit and continue to guarantee circuit protection.
Table 63 Requirements and capabilities for HP ProLiant DL servers
Intelligent
Power
Discovery
3
Data
Center
Power
Control
1,2
Calibrated
Maximum
Power
Power
Metering
Data
Center
Thermal
Mapping
Dynamic
Power
Capping
Power
Regulator
Minimum
system BIOS
version
Minimum
iLO
firmware
version
Server
model
✓✓✓✓✓✓NoneNoneProLiant
DL320
G6
4
✓✓✓✓✓
5
✓5/1/2007iLO 2
version
ProLiant
DL360 G5
Server requirements and supported capabilities for Insight Control power management 75