SVS200 (T1714-96008, June 2006)

LUN Configuration and Security Manager XP user guide for the XP12000/XP10000/SVS200 79

iSCSI target aliases can include letters, numbers, periods (.), hyphens (-), and colons (:); but cannot

include double-byte characters. iSCSI target aliases are case-sensitive. An iSCSI target alias can

consist of up to 32 characters

5. In the Host Mode list, select a host mode. When selecting a host mode, you must consider the platform

and other factors (for more information, see Table 16).

CAUTION: Do not select Reserve from the list. Reserve indicates that the host mode is not currently

supported.

6. If necessary, click Option, and select host mode options. For more information about host mode

options, see Table 17 on page 77.

Figure 38 Add New iSCSI Target pane (Option selected)

NOTE: After you click Option, the pane expands to display a list of host mode options. The No.

column indicates option numbers. Select the check box for the option you want to specify.

7. Click OK. If a message appears, click OK. The iSCSI target name and host mode appear in blue.

8. Click Apply. A confirmation message appears.

9. Click OK. Settings are applied to the array.

Registering hosts in host groups

NOTE: If you are configuring a NAS environment, you do not need to follow the procedures described

in this section. For instructions, see ”Associating host groups or iSCSI targets to logical volumes” on

page 83.

To set LU paths, you must register hosts in host groups. For example, if HP-UX and Windows hosts are

connected to a port, you must register the HP-UX and Windows hosts separately in two different host

groups.

If you are configuring a Fibre Channel environment, follow the instructions in ”Registering hosts in host

groups (when configuring Fibre Channel environments)” on page 79. If you are configuring an iSCSI

environment, follow the instructions in ”Registering hosts in iSCSI targets (when configuring iSCSI

environments)” on page 81.

Registering hosts in host groups (when configuring Fibre Channel environments)

When registering a host, you must specify the host bus adapter’s WWN. If you are unsure of the host bus

adapter’s WWN, see ”Finding an open-system host’s World Wide Name (WWN)” on page 121.