HP LineJet Printers - IGP/PGL Technical Reference Manual, 171250-001PX

Corners
49
Corners
Purpose Defines corner sets.
Mode CREATE
Format CORNER
LT; SR; SC; ER; EC; VL; HL
STOP
CORNER The Corner command; enter CORNER. Corners
expand down and to the right from the given row
and column.
LT Defines the line thickness, measured in dots. Line
thickness is based on dot dimensions of 1/72 inch
both horizontally and vertically, so that line
thickness is equal in both directions. Enter a value
of 1 or greater.
SR Defines the starting row of the corner. Enter a value
ranging from row 1 through one less than the length
of the form. Character row or dot row is specified
based on the Scale command (page 83), or use the
CP.DP format (page 26).
SC Defines the starting column of the corner. Enter a
value ranging from column 1 through one less than
the width of the form. Character column or dot
column is specified based on the Scale command
(page 83), or use the CP.DP format (page 26).
ER Defines the ending row of the corner. Enter a value
ranging from row 2 through the last row of the form.
The ending row must be greater than the starting
row. Character row or dot row is specified based on
the Scale command (page 83), or use the CP.DP
format (page 26).
EC Defines the ending column of the corner. Enter a
value ranging from column 2 through the last
column of the form. The ending column must be
greater than the starting column. Character column
or dot column is specified based on the Scale
command (page 83), or use the CP.DP format
(page 26).
VL Defines the length of the vertical arm (including the
line thickness) of each corner in the set. Enter a
value of 1 or greater specified in character or dot
rows based on the Scale command (page 83), or
use the CP.DP format (page 26).
HL Defines the length of the horizontal arm (including
the line thickness) of each corner in the set. Enter a
value of 1 or greater specified in character or dot
columns based on the Scale command (page 83),
or use the CP.DP format (page 26).