HP LineJet Printers - QMS Code V Technical Reference Manual, 171251-001PX

76
Chapter 2 Command Codes
of 00.0 through 99.9 inches. Add a fourth digit
ranging from 0 through 9 to specify 0 through 9
additional dot columns. The Code V automatically
understands the decimal between the second and
third digits for tenth inches and automatically
interprets the fourth digit as dot columns. For
example, entering 0126 specifies a 1.2-inch plus 6-
dot column position from the left edge or last
vertical line position; entering 1016 specifies a
10.1-inch plus 6-dot column position.
t Defines the vertical line thickness in dot columns.
Enter a number ranging from 1 through 9 to specify
a line thickness from 1 through 9 dots.
line2 The line position parameter is entered repeatedly
as needed for the number of lines required in the
form.
t The line thickness parameter is entered for each
vertical line position parameter.
(cc)G Enter the SFCC for your Code V configuration
followed by G, the universal terminator, or another
valid Graphics Mode command to end the input of
vertical line and form data.
(cc)- Graphics Mode CR used as a sequence terminator.
Enter the SFCC for your Code V configuration
immediately followed by - to end the command
sequence.
Comments The LF command produces vertical lines inside a box using a
single command sequence. Forms are positioned by the
parameters or commands of an Alphanumerics command
sequence (such as horizontal tabs, the justification parameter,
etc.). Therefore, one of the Alphanumerics commands must
precede an LF command.
Using appropriate values for the horizontal and vertical length
parameters constructs a variety of form shapes. The horizontal
and vertical border thickness can also be specified in varying line
thicknesses. Any number of vertical lines can be drawn inside the
form. The position of the vertical line is based on the left edge of
the form or the last vertical line drawn.
Note You must supply leading and trailing zeros for all fields.