HP LineJet Printers - QMS Code V Technical Reference Manual, 171251-001PX

Character Width
35
Character Width
Purpose Specifies a new alphanumeric width.
Mode Graphics with an Extended Graphics Command selected
Format (cc) W
wd (cc)
(cc) Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your Code V
configuration.
W The Character Width command. Enter W.
wd Defines the new character width in tenth inches.
Enter a two-digit width value ranging from 01
through 99 to define a character width of 0.1
through 9.9 inches. The Code V automatically
understands the decimal point between the digits.
(cc) Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your Code V
configuration.
Comments The W command specifies a new alphanumerics width parameter
without sending the complete alphanumerics command
sequence again. Only the character width is affected by this
command; character height, justification, rotation, or any other
parameter specification remains unchanged. The W command is
input as part of the data in one of the alphanumeric commands.
Example The following sample commands illustrate character width
changes.
^PY^-
^M10,10,000A^W02B^W30C^W05D^-
^PN^-
^PY^-
^V05,05,000I^W10G^W15P^-
^PN^-