HP LineJet Printers - QMS Code V Technical Reference Manual, 171251-001PX

276
Chapter 6 Code V Emulation Error Codes
10 Character Height Command Error
A Character Height command (H) has a non-numeric character
for the height parameter.
11 Hex Data Error
An invalid character was found while expecting a hexadecimal
value. Only numeric characters or A
, B, C, D, E, or F are allowed.
12 Vertical Justification Change Error
A Vertical Justification (J) command has a non-numeric character
for the justification parameter.
13 Form Command Error
A forms construction command (LF) has a non-numeric
parameter.
14 Undefined Line Command Error
The Line command (L) was not followed by B
, D, F, or S.
15 Logo Command Error
A user-defined logo using the Z command contains an invalid
parameter value; valid values are 1 through 9 or A through F.
16 Plot Command Error
A Plot command (Q or C) contains invalid hexadecimal data
characters. Only numeric characters or A
, B, C, D, E, or F are
allowed.
17 Not defined.
18 Vertical Duplication (Repeated Form) Terminator Missing
Error
A Vertical Duplication command (R) does not have a line
terminator.
19 Horizontal Duplication Command Error
A Horizontal Duplication command (S) contains a non-numeric
number or gap space parameter or is not followed by a line
terminator.
20 Horizontal Tab Command Error
A Horizontal Tab command (T) contains a non-numeric distance
parameter.
21 Special Function Control Character Change Command Error
A Special Function Control Character (SFCC) change command
(N) contains an illegal value for x or is not followed by a line
terminator. x can be any control character, except the following
hex characters: 00 through 09, 0A through 0F, and 4E.
22 Undefined Command Error
An SFCC is not followed by a known command character.
a. In Non-Graphics Mode, the following
characters are allowed:
#, B,C, D, E, H, I, K, L,
M, N, Q, R, S, T, U, V, W, or @.
b. Within a repeated form, the following
characters are allowed: #, D, E, H, I, K, L, M,
N, Q, R, S, T, U, W, Z, or -.