HP LineJet Printers - QMS Code V Technical Reference Manual, 171251-001PX

Lines, Solid
99
Lines, Solid
Purpose Produces solid lines.
Mode Graphics with an Extended Graphics Command selected
Format (cc) LS
horz vert (cc)-
(cc) Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your Code V
configuration.
LS The Solid Line command. Enter LS.
horz Defines the horizontal line length in tenth inches
and dot columns. Enter a three-digit horizontal
length value ranging from 000 through 999 to
define a horizontal length of 00.0 through 99.9
inches. Add a fourth digit ranging from 0 through 9
to specify 0 through 9 additional dot columns of
length.
The Code V automatically understands the decimal
between the second and third digits for tenth inches
and automatically interprets the fourth digit as dot
columns.
For example, entering 0120 specifies a 1.2-inch
plus no-dot column horizontal line length; entering
1016 specifies a 10.1-inch plus 6-dot column
horizontal line length. This command is ignored if
either length parameter is zero plus zero dots.
vert Defines the vertical length of the line in tenth inches
and dot rows. Enter a three-digit vertical length
value ranging from 000 through 999 to define a
vertical length of 00.0 through 99.9 inches. Add a
fourth digit ranging from 0 through 9 to specify 0
through 9 additional dot rows of length.
The Code V automatically understands the decimal
between the second and third digits for tenth inches
and automatically interprets the fourth digit as dot
rows.
For example, entering 0004 specifies a 0.0-inch
plus 4-dot row vertical line length; entering 0240
specifies a 2.4-inch plus no-dot row vertical line
length. This command is ignored if either length
parameter is zero plus zero dots.
(cc)- Graphics Mode CR used as a sequence terminator.
Enter the SFCC for your IGP configuration
immediately followed by - to end the command
sequence.