HP LaserJet P4010 and P4510 Series - Software Technical Reference

When you click another group box or leave the Advanced tab, invalid entries into the edit box (such as
non-numerical input, numbers less than 1, or numbers greater than 9999) change to the last valid value
that appeared in the box. The default number of copies is 1.
Problems can develop when a software program and the driver it is running on both allow the user to
set the number of copies to print. In most cases, the software program and the driver communicate, so
that the number of copies set in one location (such as the program) appears in the other (such as the
driver). For some software programs, this communication does not take place, and the copies values
are treated independently. For example, setting 10 copies in the program and then setting 10 copies in
the driver might result in the printer making 100 copies (10 x 10). Set the number of copies in the software
program, whenever possible.
Graphic settings
The Graphic settings contain the following controls.
●
TrueType Font settings
TrueType Font settings
This option specifies the TrueType Font settings. The following settings are available:
●
Substitute with Device Font. This setting causes the printer to use equivalent fonts for printing
documents that contain TrueType fonts. This permits faster printing; however, special characters
that the printer font does not support might be lost. This is the default setting.
●
Download as Softfont. This setting causes TrueType fonts to be downloaded and used for
printing, instead of the fonts installed through the printer.
Document Options
The Document Options settings contain the following controls:
●
Advanced Printing Features
●
Print optimizations
●
PostScript Options (PS Emulation only)
●
Printer Features
●
Layout Options
Advanced Printing Features
When the Advanced Printing Features setting is Enabled, metafile spooling is turned on and the
Finishing tab options such as Page Order, Booklet Layout, and Pages per Sheet are available,
depending on the printer. For normal printing, leave the Advanced Printing Features setting at the
default (Enabled). If compatibility problems occur, disable the feature. However, some advanced
printing features might still be available in the print driver, even if they have been disabled. If you select
an advanced printing feature in the print driver that has been disabled on the Advanced tab, the feature
is automatically turned on again.
Print optimizations
NOTE: Print Optimization settings are available only in the HP PCL 6 and HP PCL 5 drivers. They are
not available in the PS emulation.
122 Chapter 4 HP PCL 5, PCL 6, and PS emulation drivers for Windows ENWW