HP Digital Sender Module - Administrator's Guide
54 Chapter 3 - Troubleshooting
EN
079/05 The Email subsystem
failed during initialization.
An error occurred while the e-
mail subsystem was being
initialized.
●
Make sure the PC has
enough memory.
●
Restart the HP Digital
Sender Module software.
●
If the problem persists,
contact your HP-authorized
dealer.
080/00 Address Book error
reading entry: X
An entry was not found in the
HP Digital Sender Module
database.
●
Use the Address Book
Manager to make sure the
database contains the
correct addresses.
●
Go to the Configuration
Utility and reinitialize the
installed devices.
●
If the problem persists,
contact your HP-authorized
dealer.
081/00 Job retry error. Cannot
read job information from the
disk.
An error occurred while
retrying a previously
uncompleted job.
●
Make sure there are no
disk errors.
●
Restart the HP Digital
Sender Module software.
●
If the problem persists,
contact your HP-authorized
dealer.
081/01 Error writing job
information to the disk.
Cannot write job information to
the PC hard disk. Incapable of
retrying the job.
●
Make sure there are no
disk errors.
●
Make sure the disk where
the Digital Service Module
is installed is not full
●
Restart the HP Digital
Sender Module software.
●
If the problem persists,
contact your HP-authorized
dealer.
082/00 Firmware has not been
upgraded on the X printer.
The firmware on the MFP was
not updated when the HP
Digital Sender Module was
upgraded.
●
Go to the Configuration
Utility and reinitialize the
device
Activity Log Messages (continued)