HP LaserJet 4250/4350 Series - User Guide

To set the jam-recovery response
1. Press M
ENU to open the menus.
2.
Press
(D OWN button) to highlight CONFIGURE DEVICE.
3.
Press
(S ELECT button) to select CONFIGURE DEVICE.
4.
Press
(D OWN button) to highlight SYSTEM SETUP.
5.
Press
(S ELECT button) to select SYSTEM SETUP.
6.
Press
(D OWN button) to highlight JAM RECOVERY.
7.
Press
(S ELECT button) to select JAM RECOVERY.
8.
Press
(U P button) or (D OWN button) to select the appropriate setting.
9.
Press
(S ELECT button) to set the selection.
10. Press M
ENU to exit the menu.
RAM disk
This option determines how the RAM disk feature is configured. This option is only available
if no hard disk is installed and the printer has at least 8 MB of free memory. The default is
AUTO.
● AUTO. The printer determines the optimal RAM disk size based on the amount of
available memory.
● OFF. The RAM disk is disabled, but a minimal RAM disk is still active (sufficient to scan
one page).
To set the RAM disk
1. Press M
ENU to open the menus.
2.
Press
(D OWN button) to highlight CONFIGURE DEVICE.
3.
Press
(S ELECT button) to select CONFIGURE DEVICE.
4.
Press
(D OWN button) to highlight SYSTEM SETUP.
5.
Press
(S ELECT button) to select SYSTEM SETUP.
6.
Press
(D OWN button) to highlight RAM DISK.
7.
Press
(S ELECT button) to select RAM DISK.
8.
Press
(U P button) or (D OWN button) to select the appropriate setting.
9.
Press
(S ELECT button) to set the selection.
10. Press M
ENU to exit the menu.
Language
If LANGUAGE appears in English on the control panel, use the following procedure.
Otherwise, turn the printer off and then on again. When XXX MB appears, press and hold
(S ELECT button). When all three control panel lights are lit, release (S ELECT button) and use
the following procedure to set the language.
24 Chapter 1 Printer basics ENWW