6.1 HP IBRIX X9000 Network Storage System Installation Guide (TA768-96058, June 2012)

The wizard now sets up the blade based on the information you entered.
7. The setup wizard next configures the chassis on the X9730 system. See the HP IBRIX X9000
Network Storage System Network Best Practices Guide for detailed information about the
chassis components. (This step will fail if the OA IP address has not been set up or if the blade
cannot communicate with the OA.) The Active Virtual Connect is by default the Virtual Connect
in interconnect bay 1. If the system is at factory defaults, the administrator passwords for OA
and Virtual Connect are on the labels affixed to the back of the chassis. If the passwords have
been reset, enter the new passwords.
IMPORTANT: If you are using the default unified network layout, select OK on the Confirming
Onboard Administrator and Virtual Connect Settings dialog box and go to step 8. To use a
different network layout, press F2.
When you press F2, the following screen appears.
When you answer Yes to configure a dedicated management network, the following screen
appears. Specify the number of networks for your layout on the Get Total Networks dialog
box.
52 Installing X9730 systems