6.1 HP IBRIX X9000 Network Storage System Installation Guide (TA768-96058, June 2012)

To configure a server, select the server on the File Servers page and click Configure. Enter the host
name and IP address of the server. If the wizard can locate the subnet masks and iLO IP address,
it will fill in those values.
If your cluster should include servers that were not listed on the File Servers page, configure an IP
address manually on the servers, using their local console setup screens. Then click Add on the
File Servers page to add the servers to the cluster. You can enter a single IP address on the Add
Servers dialog box, or you can enter a range of addresses and the wizard will locate all servers
with IP addresses in the range.
HP recommends that you create a single file system using all of the available storage. You can
create this file system on the Create a Default File System page. You can also create NFS and CIFS
shares on the file system.
34 Configuring the cluster with the Getting Started Wizard (X9300/X9320 systems)