HP HSR6802 HSR6804 HSR6808 Routers Installation Guide

48
Figure 62 Pulling the SFE-X1 out of the slot (HSR6808)
4. Install a new SFE-X1. For the installation procedure, see "Installing an SFE-X1 switching fabric
module."
If you do not install a new SFE-X1 in the slot, install a filler panel.
Replacing an LPU
CAUTION:
To avoid hardware damage, do not replace the LPU when its RUN LED is fast flashing.
To replace an LPU, for example, FIP-210:
1. Face the front of the router and locate the FIP module to be removed.
2. Use a Phillips screwdriver to completely loosen the captive screws of the FIP module.
3. Holding the ejector levers of the FIP module with both hands, pull the ejector levers outward, and
gently pull the FIP module out of the slot along the slide rails.