958-000324-002, March 2005)

Manually configuring private LAN addresses using DHCP

To configure TCP/IP network information for the private LAN connection (LAN 2):

1. At the LCD panel, press ENTER. The Welcome!! or o perational information

message changes to the following (Figure 27):

Figure 27 LCD panel (Input Password)

2. Using the

button to increm ent a digit, the button to decrement a digit,

the

button to move the cursor left, and the button to move the cursor

right, input the default password (9999), then press ENTER.TheLAN 1

Setting?? message is displayed at the LCD panel.

3. Press the

button until the LAN 2 Setting?? message is displayed at

the LCD panel.

4. Press ENTE R and the following message is displayed (Figure 28) to allow

the selection of DHCP.

Figure 28 LCD panel (Use DHCP)

5. Usethearrowkeysasdescribedinstep2andselectYES to use DH CP, then

press ENTER. The following message is displayed (Figure 29):

Figure 29 LCD panel (Auto G et DNS)

6. Do one of the following:

• Use the up and down arrow keys a s d escribed in step 2 to select YES,then

press ENTER. The DNS address is auto-detected and recorded. Proceed to

step 8.

• Select NO by pressing ENTER. The following message is displayed (Figure

30).

HP StorageWorks HA-Fabric Manager Appliance installation guide F W07.00.00/HAFM

SW 08.06.00