Upgrading and Servicing Guide

Removing and
Replacing a Hard Disk
Drive
Computer features may vary by model.
15 – 20 minutes
Before you begin
Observe the following requirements before removing
and replacing the hard disk drive.
WARNING! Never open the cover with the power
applied. You might damage your computer or be
injured by the spinning the fan blades.
WARNING! Avoid touching sharp edge inside the
computer.
WARNING! Keep your hands away from the
moving fan.
WARNING! Keep fingers and tools clear of the
fan when the power is applied.
CAUTION: Static electricity can damage the
electronic components inside the computer. Discharge
static electricity by touching the metal cage of the
computer before touching any internal parts or
electronic components.
IMPORTANT: A hard disk drive is extremely
sensitive to shock impact. Do not bang or drop it. Do
not touch the circuit board. Static electricity can
damage the drive.
Tools Needed
Flathead/T15 Torx screwdriver
Small screws are easily lost. Remove screws over a
surface that enables you to retrieve them if they fall.
Removing the hard disk drive
1. Remove any media or storage devices such as
CDs, DVDs, and USB.
2. Close all programs, and then shut down your
operating system.
3. Unplug the computer by disconnecting the
power cord and all attached cables from the
back of the computer.
4. Using a flathead or Torx screwdriver, loosen the
screw on the back panel that secures the panel
to the computer.
2 Upgrading and Servicing Guide Features may vary by model.