DCFM Professional Plus User Manual (53-1001774-01, June 2010)

DCFM Professional Plus User Manual 41
53-1001774-01
2
12. Enter a context name In the Context Name field.
13. Select the authorization protocol in the Auth Protocol field.
14. Enter the authorization password in the Auth Password field.
• If you selected Configure for 256-Port_Director_Name, go to step 17.
• If you did not select Configure for 256-Port_Director_Name, continue with step 15.
15. Select the privacy protocol in the Priv Protocol field.
16. Enter the privacy password in the Priv Password field.
17. Click OK on the Address Properties dialog box.
If the seed switch is not partitioned, continue with step 18.
If the seed switch is partitioned, the Undiscovered Seed Switches dialog box displays.
a. Select the Select check box for each undiscovered seed switch to discover their fabrics.
b. Click OK on the Undiscovered Seed Switches dialog box.
18. Click OK on the Discover Setup dialog box.
Reverting to a default SNMP community string
1. Select Discover > Setup.
The Discover Setup dialog box displays.
2. Select an IP address from the Available Addresses table.
3. Click Edit.
The Address Properties dialog box displays.
4. Click the SNMP tab.
5. Click Default ‘public’ and Default ‘private.’
6. Click OK on the Address Properties dialog box.
7. Click OK on the Discover Setup dialog box.
Deleting a fabric
If you decide you no longer want the Management application to discover and monitor a specific
fabric, you can delete it. Deleting a fabric also deletes the fabric data on the server (both system
collected and user-defined data) except for user-assigned names for the device port, device node,
and device enclosure information.
To delete a fabric, complete the following steps.
1. Select Discovery > Setup.
The Discover Setup dialog box displays.
2. Select the fabric for which you want to delete from the Discovered Addresses table.
3. Click Delete.
You are prompted to confirm that you want to delete the fabric.