Converged Enhanced Ethernet Command Reference v6.4.0 (53-1001762-01, June 2010)

Converged Enhanced Ethernet Command Reference 227

53-1001762-01

dot1x timeout tx-period

DRAFT: BROCADE CONFIDENTIAL

dot1x timeout tx-period

Sets the number of seconds that the switch waits for a response to an Extensible Authentication

Protocol (EAP) request or identity frame from the client before retransmitting the request.

Synopsis dot1x timeout tx-period seconds

Operands seconds Specifies the time in seconds between successive request ID attempts. The

range of valid values is 1-65535.

Defaults The default timeout is 30 seconds.

Command

Modes

Interface configuration mode

Description Use this command to set the interval between successive attempts to request an ID (EAP ID Req).

Usage

Guidelines

There are no usage guidelines for this command.

Examples To set 34 as the number of seconds to wait for a response to an EAP-request or identity frame from

the client before retransmitting the request:

switch(config)#interface tengigabitethernet 0/1

switch(config-if)#dot1x timeout tx-period 34