Brocade Fabric OS Command Reference Manual Supporting Fabric OS v7.0.0 (April 2011)

Fabric OS Command Reference 151
53-1001764-01
configureChassis
22
System attributes
The following system-related parameters are configurable on a Virtual
Fabric-aware switch.
system.blade.bladeFaultOnHwErrMsk
If this field is set to a value other than 0, then any nonfatal HW ASIC data parity
error causes the problem blade to be powered off. The valid range is 0x0 to 0xffff.
The default value is 0x0.
system.cpuLoad
Sets a threshold to define internally when the CPU is busy. The default threshold
is 121, which represents a CPU instantaneous load average of 1.21 in the or top
command. The range is 10 to 121 (representing CPU load thresholds of .10 to
1.21).
system.i2cTurboCnfg
For internal use only.
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS None
EXAMPLES To enable signature validation for downloading firmware:
switch:admin> configurechassis
Configure...
cfgload attributes (yes, y, no, n): [no] y
Enforce secure config Upload/Download (yes, y, no, n): [no]
Enforce signature validation for firmware (yes, y, no, n): [no]y
Add Suffix to the uploaded file name (yes, y, no, n): [no]
Custom attributes (yes, y, no, n): [no]
system attributes (yes, y, no, n): [no]
To add a suffix to the uploaded file name:
switch:admin> configurechassis
Configure...
cfgload attributes (yes, y, no, n): [no] y
Enforce secure config Upload/Download (yes, y, no, n): [no]
Enforce signature validation for firmware (yes, y, no, n): [no]
Add Suffix to the uploaded file name (yes, y, no, n): [no] y
Custom attributes (yes, y, no, n): [no]
system attributes (yes, y, no, n): [no]
To upload and list the configuration file locally:
switch:admin> configupload
configupload
Protocol (scp, sftp, local) [scp]:
Server Name or IP Address [host]: 10.70.212.152
User Name [user]: admin