HP StorageWorks Enterprise Modular Library E-Series 71e Getting Started (AH876-96007, May 2010)

2. At the rear of the library, guide the notches on the bottom corners
of the 8U base module onto the mounting brackets. Slide the 8U
base module completely into the rack.
NOTE:
Your library might look different.
3. At the front of the library, turn the center-door knob onequarter turn
counterclockwise and open the center door of the library.
4. Keep the center door open and turn the center-door knob one-quarter
turn clockwise to lower the door locking lever on the top of the door.
CAUTION:
The door locking lever must be down before you install
the robotics unit.
5. Open the load port door on the 8U base module. Inside the front
of the library, press the load port door latch to open the load port
door.
6. Attach the 8U base module to the front of the rack with four T-25
panhead screws.
7. Close the load port door on the 8U base module.
4 Install the 4U base module
WARNING!
The 4U base module weighs 12 kg (27 lb). Be careful when
lifting. Use a cart, tabletop, or mechanical device to lift, position,
and secure the module.
1. Remove the cover from the left side of the 4U base module. To
remove the cover, loosen the bottom thumbscrew.
Page 3