HP StorageWorks Clustered File System 3.6.1 Windows Storage Server Edition administration guide (AG515 - 96007, August 2008)
Chapter 9: Configure PSFS Filesystems 111
• [--blocksize [4K|8K]]
The block size for the filesystem.
•[--reuse]
This option applies only to mx fs create. Reuse a psd device. If you
will be creating a filesystem on a psd device that is associated with an
unimported volume, the -reuse option must be used to tell the
command to reuse the device. Without this option, the attempt to
create the filesystem will fail because the device contains a volume
signature. Be sure that you do not need the unimported dynamic
volume before doing this.
•[--quotas]
Enable quotas on the filesystem.
•[--defaultUserHardLimit <unlimited | #{K,M,G,T}>]
The default hard limit on the filesystem. unlimited specifies that there
is no default. The optional size modifiers specify that the size is in
kilobytes (K), megabytes (M), gigabytes (G), or terabytes (T). If a
modifier is not specified, the size will be calculated in bytes. (The
default is rounded down to the nearest filesystem block.)
•[--defaultUserSoftLimit <unlimited | #{K,M,G,T}>]
The default soft limit. unlimited specifies that there is no default. The
optional size modifiers are the same as --defaultUserHardLimit.
•[--enforceHardLimit <enable | disable>]
Whether the hard limit should be enforced (file operations that will
result in exceeding the limit are denied). The default is disable.
•[--logHardLimitViolations <enable | disable>]
Whether file operations that result in exceeding a user’s hard limit
should be logged in the system event log.The default is disable.
•[--logSoftLimitViolations <enable | disable>]
Whether file operations that result in exceeding a user’s soft limit
should be logged in the system event log. The default is disable.