HP Designjet Z3100 Photo Printer Series - Users Guide

then Advanced > Sleep mode wait time. Highlight the wait time you want and then press the OK key.
You can set the time to 30, 60, 120, 150, 180, 210, or 240 minutes.
Turn the buzzer on and off
To turn the printer's buzzer on or off, press the Menu key to return to the main menu and select the
Setup menu icon
, then Front panel options > Enable buzzer, and highlight on or off and press
the OK key. The default buzzer is set to on.
Change the front-panel display contrast
To change the contrast of the front-panel display, select the Setup menu icon , then Front panel
options > Select display contrast, and enter a value using the Up or Down key. Press the OK key to
set the value. The default contrast is set to 50.
Change the units of measurement
To change the units of measurement in the front-panel display, select the Setup menu icon ,
then Advanced > Select units, and select English or Metric. By default the units are set to metric.
Configure network settings
To configure the network settings from HP Easy Printer Care (Windows), select Settings tab > Network
Settings. From HP Printer Utility (Mac OS), select Configuration Group > Network Settings. You can
view and configure the following network settings.
●
IP Configuration method: specify the way to set an IP address between BOOTP, DHCP, Auto
IP, and Manual
●
Host name: specify an IP name for the network device, the name may contain up to 32 ASCII
characters
●
IP address: specify the IP address on the print server, duplicate IP addresses on a TCP/IP network
are not allowed
NOTE If you change the current IP address and click Apply, the browser loses the current
connection to the print server because it is pointing to the old address. To reconnect, browse
to the new IP address.
●
Subnet mask: specify a subnet mask, which is a 32-bit number applied to an IP address to
determine which bits specify the network and subnet and which bits uniquely specify the node
●
Default gateway: specify the IP address of a router or computer that is used to connect to other
networks or sub-networks, if none exist, use the IP address of the computer or the IP address of
the print server
●
Domain name: specify the name of the DNS domain that the print server resides in, for example,
support.hp.com, note that it does not include the host name; it is not the fully qualified domain
name, such as printer1.support.hp.com
●
Idle timeout: specify the number of seconds that an idle connection is allowed to remain open,
270 is the default value, if set to zero, the timeout is disabled and TCP/IP connections remain open
until closed by the other node (such as a workstation) on the network
ENWW Turn the buzzer on and off 21
Personalizing the printer