HP Designjet T2300 eMFP Series - Using Your Product

10. Switch on the product.
11. Reload the roll, or load a new sheet see Printer paper handling on page 48.
NOTE: If you find that there is still some paper causing an obstruction within the printer, restart the
procedure and carefully remove all pieces of paper.
A strip stays on the output tray and generates jams
If a small piece of paper (200 mm or smaller) has been cut, such as before (if new roll) and after a full-
bleed print or after the front panel option Form feed and cut has been used, the cut strip remains in
the output tray. Only when the printer is not printing, reach into the tray and remove the strip.
The printer displays out of paper when paper is
available
If the roll has become loose from its core, it will not feed correctly and the printer will not load the
paper. If possible, tighten the paper to its core or load a new roll.
Prints do not fall neatly into the basket
●
Ensure the basket is correctly installed.
●
Ensure the basket is open.
ENWW
A strip stays on the output tray and generates jams
181