HP Designjet T1120 HD-MFP - Assembly Instructions: English

Turn the legs upside down, and attach the
two feet to the left and right legs using four
M6×30 screws (two for each foot). Tighten
the screws with the T-handle Torx driver
T30 found in the assembly kit.
7
Using three people; two to lift, and one to
position, lift the scanner into place locating
the rubber feet in the holes indicated.
10
Fix with the four special screws using the
T-handle hex driver 2.5mm.
11 12
At this point you must decide on which side you
are going to t the touch screen assembly. This
can be tted on the left or right side of the stand.
The next steps, 12 to 22, explain how to t
the touch screen assembly to the right side of the
stand.
To t the touch screen assembly to the left side
of the stand, using the same parts, just ‘mirror’
the assembly procedure described here.
Attach the two bracket covers to the
touch screen bracket using two screws
on the straight bracket cover and two
screws and two starwashers on the
triangular bracket cover.
M5X14
Turn the legs upside down, and attach the
two feet to the left and right legs using four
M6×30 screws (two for each foot). Tighten
the screws with the T-handle Torx driver
T30 found in the assembly kit.
7
Tighten up all screws rmly.
6
Connect the rear table. This is tted by
locating the four guide pins on the rear of
the table into the rubber-framed holes on the
top bar.
7 9
Using two people, remove the scanner from
the box. The third person should place some
packaging boxes (we recommend the foam
end packs from the scanner box) on the
oor.
8
Place the scanner onto the packaging
boxes.
Attach scanner to stand
Touch screen assembly
HP DesignJet Information EngineeringHP DesignJet Information Engineering