HP Designjet T1120 Printer Series User's Guide: English

6. Ensure the end of the blue handle catches the wire loop on the near side of the carriage.
7. Lower the handle to rest on the carriage cover.
When all the printheads have been inserted correctly and are accepted by the printer, the printer
beeps.
NOTE: If the printer does not beep when you insert the printhead and the Replace message
appears on the front-panel display, the printhead may need to be reinserted.
8. Close the window.
9. The front-panel display confirms that all printheads are correctly inserted. The printer starts
checking and preparing the printheads. The default routine process, when all printheads are
changed, takes 10 minutes. If the printer finds problems in preparing the printheads, it takes longer,
up to 45 minutes. For a single printhead insertion, the times vary between 2 and 40 minutes. After
all printheads are checked and prepared, the printhead realignment procedure runs automatically
if paper is loaded, see
Align the printheads on page 172.
ENWW Insert a printhead 123
Ink and printheads