HP Designjet L65500 Printer and HP Scitex LX Printer Family - Installation guide (third edition)
Table Of Contents
- Safety precautions
- Introduction
- Receive the shipment
- Set up the printer in the final position
- Connect the power cables
- Configure the electrical system
- Purge the ink system
- Prepare the printer
- Prepare for printing
- Prepare the HP Internal Print Server (Japan and Russia only)
- Manually configure the printer’s IP address
- Change the Windows Vista language
7. Ensure that the blue tabs on the filters are correctly engaged with the hooks on the containers,
otherwise the containers may not close completely.
8. Lower the container into position.
9. Lower the carriage cover and close the door. Press the OK key on the front panel.
10. When you finish the purging process and are ready to start the printer, select Check cleaner
roll from the Ink System menu
in normal printer mode.
Install the computer, monitor, LAN switch, tray, keyboard
and mouse
Manpower Tools Time
1 person T20, T30 Phillips screwdriver 30 minutes
NOTE: Perform this task while you fill the intermediate ink tanks.
1. Install the keyboard platform with four T30 screws (two of which you will find already screwed into
the printer), and route the keyboard and mouse cables through the hole in the top cover.
NOTE: Use the longer of the two power cables (computer and monitor) to power the monitor.
WARNING! Do not route the keyboard, mouse or monitor cables over the front panel cable.
ENWW Install the computer, monitor, LAN switch, tray, keyboard and mouse 53