HP Designjet L65500 Printer and HP Scitex LX Printer Family - Installation guide (third edition)
Table Of Contents
- Safety precautions
- Introduction
- Receive the shipment
- Set up the printer in the final position
- Connect the power cables
- Configure the electrical system
- Purge the ink system
- Prepare the printer
- Prepare for printing
- Prepare the HP Internal Print Server (Japan and Russia only)
- Manually configure the printer’s IP address
- Change the Windows Vista language
20. When the ink cartridge has been installed correctly, press OK.
21. Press OK to confirm that you have installed the ink cartridge.
22. The printer checks the pressure sensors.
If the pressure is correct, press OK to continue.
If the pressure sensor value is below the limits or is negative then follow the steps in Problems with
the ink sensor value on page 42.
23. Enter the quantity of ink you extracted from the ink cartridge. If you extracted ink from the cartridge
twice and purged the ISM in two steps, enter the total sum of the ink extracted.
24. Select the next color and repeat.
ENWW 41