HP DesignJet 755CM Printer User's Guide - C3198-60051

Full menu mode
only
Utilities
Accuracy
Recalibrate
Full menu mode only
Utilities
Accuracy
Restore factory
7-6
Company confidential. Postillo/755CM User’s Guide Final Freeze Status:Frozen
This is the cyan on page 7-6 (seq: 146)
This is the black on page 7-6 (seq: 146)
To Recalibrate the Printer
1 Choose your media type (sheet or roll). If recalibrating for a non-standard media
type, use that type. Otherwise HP Matte Film will give greatest accuracy.
2 Choose your media size. This must be either E/A0 or D/A1.
3 Go to
Recalibrate in the front-panel menus, as shown above left.
4 Choose
Create pattern. The message Calibrating is displayed. If sheet media is
loaded, this will be ejected. If roll media is loaded, you are asked to remove it.
5 When prompted, load your media, using the normal procedure. If using sheet
media, load it in portrait orientation, unless you chose D/A1-size media for an
E/A0-size printer, in which case load it in landscape orientation.
6 When the calibration print is finished, remove it.
7 Unload any unprinted media.
8
Rotate the sheet 90_ counterclockwise and reload it printed side down, so that
the two black arrows go into the printer first.
123
0030
9 Go to Recalibrate again, and this time choose Measure pattern.
10 When the printer has finished measuring and has ejected the sheet, the recalibration
routine is finished.
Once created, you can use this calibration sheet to recalibrate the printer’s accuracy
again later. Store the sheet flat or rolled with the printed side out. If the film takes
a curl in the wrong direction it can become impossible to reload.
To Restore the Factory’s Calibration
From the Accuracy menu, choose Restore factory. That’s all.
Reconfiguring Your Printer
Recalibrating Your Printer for Accuracy