HP DesignJet 5000 Series Printer - Setup Poster

Page 8
If all the printheads have been installed correctly,
the front panel displays the above.
Close the cover on the carriage and shut the
window.
The front panel displays the above.
Open the printer’s right door below the front
panel.
All printheads OK,
Close cover and
window to
continue
INK STARTUP
Open right door to
access printhead
cleaners
st050
Insert each printhead cleaner into the correct color
slot location, as indicated by the arrow shown
above.
When the printhead cleaner has been pushed all
the way in, press inwards and downwards as
indicated by the arrow shown above, until it clicks
into place.
When you have inserted the all printhead cleaners
into the printhead service station, close the door.
st071
st072
st073
The front panel displays the above.
The printer will now start the printhead test.
If it is successful, the front panel will instruct you
to load the media; then the printer will run the
printhead alignment check.
INK STARTUP
Checking printhead
CLEANERS
11. Installing a roll
Remove the blue colored stop A from the left-hand
end of the spindle, and stand the spindle vertically,
with the fixed stop B on the floor.
Slide the new roll of media on to the spindle.
Make sure the orientation of the paper is loaded
exactly as shown. The blue media guide must be
on the left.
Put the removable stop onto the spindle and push it
on as far as it will go.
st002
A
B
st003
st005
With the blue colored roll stop on the left, slide the
spindle into the printer as shown by the arrows A
and B. The paper should hang down from the roll
exactly as shown.
st006
A
B