HP DesignJet 5000 Series Printer - Setup Poster

Page 3
Carefully lift printer into the upright position.
Remove the media rolls and spindles from the
Shipping Container.
st524a
Anti-slip pads
st521
4. More unpacking
Remove the End Packings and the plastic covering
from the printer.
Tear off and discard the anti-slip material from the
wheels. Important: You do not need to lift the
printer.
Install the two stabilizers onto the rear of the feet
as shown. Make sure you install both stabilizers
onto the rear of the feet.
st525
st526
st163
Install the pins into the two stabilizers and secure
with the retaining clips.
Adjust the stabilizer feet so that the wheels do not
touch the floor.
Remove the Packing Tape and the Desiccant Bag.
Side view
Packing Strap
Desiccant Bag
st527
5. Install the Take-Up Reel Assembly
Install the Take-Up Reel as shown in the following
steps.
Loosen the four screws shown above.
Release the clamp on the left-hand assembly by
removing the screw.
st530
st531
Remove the protective covering from the Printer
Window.
Open the window and remove the Carriage
Packing Material.
Install the Pocket on the rear of the printer.
st528
st529
st569